NEC Xen IPK - Caller ID;Preset Dial Outgoing CO Selection

450 – Chapter 1 DRAFT 3 Caller ID/Preset Dial Outgoing CO Selection, 4-44
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
4-44
System Mode
4
Submode
—
Data No.
44
PC Programming
+ AI
Caller ID/Preset Dial
Outgoing CO Selection
General Description
Use this Memory Block to assign the Trunk Group, Route Advanced Group, or Closed
Numbering Group that is seized for Caller ID Outgoing Calls and preset dial. Use the Caller ID
Scroll key to access the Caller ID to be called.
Display
Programming Procedures
1
Go off-line.
2
Press LK4 + DD to access the Memory Block.
3
Use the dial pad to enter Setting Data.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
R to select next Tel Port No.
Default Values
Not specified
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. Setting Data is Access Code Assignment in Memory Blocks , 1-1-46, , 1-1-47, , 1-1-48 Access Code (1-Digit, 2-Digit,
or 3-Digit) Assignment. For example: Dial 9 (101)
→ Trunk Group 1 .
2. Assign the Caller ID Scroll key using Memory Blocks , 2-06 , Line Key Selection for Tenant Mode or , 4-12 , Line Key
Selection for Telephone Mode.
3. Telephone ports A0~C0 are ports 100~120.
0 1 / 4 4 :
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Setting Data