NEC Xen IPK - IP K-CCIS Selection

264 – Chapter 1 DRAFT 3 IP K-CCIS Selection, 1-11-03
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-11-03
System Mode
1
Submode
11
Data No.
03
PC Programming
+ AD
IP K-CCIS Selection
General Description
Use this Memory Block to assign the IAD(8)-U( ) ETU used for K-CCIS over IP.
Applicable for R2000 and above.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK11 + KC to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data. The next Memory Block is displayed.
5
Program the next Memory Block or pressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-11 Centralised Billing Allow/Deny Selection
1-15-12 Centralised Billing - Point Code of Center Office Assignment
1-15-13 Centralised Day/Night Switching for Remote Office Assignment
1-15-14 Centralised Day/Night Switching for Main Office Assignment
1-15-15 Centralised BLF Send Point Code Assignment
1-15-16 Centralised BLF Send Extension Number Assignment
1-15-17 Centralised BLF Send Time Assignment
1-15-18 Centralised BLF Display Extension Number Assignment
N
1. The IAD(8)-U( ) ETU is programmed as a DTI (DTI4 or DTI8) ETU in Memory Block 7-1 (Card Interface
Slot Assignment) when used for K-CCIS over IP
.
2.
Assign this Memory Block to YS when IAD(8)-U( ) ETUs are installed with one of the following
applications loaded.
IP CCH ETU [IP(K-CCIS)]
IP CCH ETU for NEAX [IP(K-CCIS) to NEAX (Point-to-Multipoint)]
0 1 / 0 3 : C C I S O I P N O
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
DTI No.
(01~08)