NEC Xen IPK - Centralised BLF Send Point Code Assignment

320 – Chapter 1 DRAFT 3 Centralised BLF Send Point Code Assignment, 1-15-15
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-15-15
System Mode
1
Submode
15
Data No.
15
PC Programming
+ AW
Centralised BLF Send Point
Code Assignment
General Description
Use this Memory Block to assign the Point Codes and the CCH Channel to control remote
systems for Centralised Day/Night Switching
.
System Software R2000 or higher is required.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK15 + AE to access the Memory Block.
3
Use dial pad keys to enter Group No., CCH Channel, and Point Code.
Press Redial + 1 to assign i for K-CCIS over IP (System Software R2000 or
higher).
Note: Use the following to enter data:
Jto move cursor left.
Lto move cursor right.
K~Ito enter numeric data.
Point Code range is 0001~16367.
Group No. 1~8 can be assigned.
Default Values
:
All Tables Not Specified.
4
PressNto write the data, and display the next Memory Block.
5 Repeat Steps 3 and 4 for each Group No.
6
Program the next Memory Block or p
ressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
1-8-08 Class of Service (Station) Feature Selection 2 (Page 6, LK 2)
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1 5 : S E N D 1 : = 0
T I M E D I S P L A Y
Data
No.
CCH
C-Channel
1~4, 1
Title
Point
Code
Group
No.
1~8