4-35, Voice Mail/SLT Selection DRAFT 3 Chapter 1 – 439
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
4-35
System Mode
4
Submode
—
Data No.
35
PC Programming
+ BTI
Voice Mail/SLT Selection
General Description
Use this memory block to specify whether or not a Voice Mail system is interfaced with the
system for Single Line Telephone ports.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
No Ys
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK4 +CE to access the Memory Block.
3
Press the corresponding CO/PBX line key to change data option.
Note: Use the following to change option:
Press
R to go to next Tel Port No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-2 Telephone Type Assignment.
N
1. The SLT(1)-U( ) ADP Adapter and the ADA(2)-W(BK)/(SW) Unit do not support Voice Mail.
2. Only 16 Voice Mail ports are supported by this system.
3. Telephone ports A0~AC are ports 100~120.
0 1 / 3 5 : V M A I L N O
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Setting
Data
Title
To Next Page
Loading...
