232 – Chapter 1 DRAFT 3 VRS Message Recording Time Selection, 1-8-12
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0
December 2004
1-8-12
System Mode
1
Submode
8
Data No.
12
PC Programming
+ AR
VRS Message Recording
Time Selection
General Description
Use this Memory Block to specify the length and number of messages for each of the eight Voice
Recording Service (VRS) channels.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Recording
Time
15 sec.
16 messages
Recording
Time
30 sec.
8 messages
Recording
Time
60 sec.
4 messages
Recording
Time
120 sec.
2 messages
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK8 + ABto access the Memory Block.
3
Press corresponding CO/PBX line key to change data option.
Note: Use the following to enter VRS Channel:
K~Hto enter numeric data
Default Values
All VRS Channels
Recording Time = 15 seconds,
16 messages
4
PressNto write the data and advance to the next VRS Channel.
5
After entering last data, pressNto write the data.
6
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
Voice Recording Services Channel 1 has 240 seconds for message recording. The number of messages that can be
recorded depends on message length. Divide 240 by the message length to obtain number.
1 2 : V R S 1 1 5 s x 1 6
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
VRS
Chan.
To Next Page
Loading...
