8-8-8800, Second Initialisation DRAFT 3 Chapter 1 – 517
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
8-8-8800
System Mode
8
CO-Line
8
Data No.
8800
PC Programming
+ CI
Second Initialisation
General Description
Use this Memory Block to initialise all the system hardware. All system software and user
programming are retained after the Second Initialisation.
Display
Programming Procedures
1
Go off-line.
2
Press LK8 + LK8 + HHKK to access the Memory Block.
3
When the system display prompt indicates CPU RESET?, the first four CO/PBX lines light red.
4
PressNto begin the initialisation process.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
IMPORTANT
If VMS, FMS, ACD and/or IPT cards installed in the system, please ensure all cards have completed their startup
sequence before performing a second initialisation.
These cards are considered fully ‘started up’ about 5 minutes after power is applied.
C P U R E S E T ?
T I M E D I S P L A Y
WWWW
Red Red Red Red
To Next Page
Loading...
