NEC Xen IPK - Synchronous Ringing Selection

1-1-59, Synchronous Ringing Selection DRAFT 3 Chapter 1 – 97
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-59
System Mode
1
Submode
1
Data No.
59
PC Programming
+ BCS
Synchronous Ringing
Selection
General Description
Use this Memory Block to specify whether or not CO/PBX calls follow Synchronous Ringing.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the
default setting.
Yes No
LK 5LK 6LK 7LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + EI to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. Synchronous Ringing does not apply to incoming DID calls, off-hook ringing calls, or CO/PBX ring transfer calls.
2. Do not program this Memory Block if Memory Block 1-1-59 Synchronous Ringing Selection is assigned Yes.
5 9 : S Y N C H R O N U S Y S
T I M E D I S P L A Y
Data
No.
Title
Function
No.