4-03, Doorphone Chime Assignment (Day Mode) DRAFT 3 Chapter 1 – 409
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
4-03
System Mode
4
Submode
—
Data No.
03
PC Programming
+ BTP
Doorphone Chime Assignment
(Day Mode)
General Description
Use this Memory Block to assign up to four doorphones to ring at each station in the day mode.
Display
Settings
Page 1 (Ports 01~08)
LK 1LK 2LK 3LK 4
There is no
default setting.
DP1 DP2 DP3 DP4
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK4 + KC to access the Memory Block.
3
Use LK1~LK4 to assign ringing for doorphone 1~4.
Default Values
Port 01 and 02 ring for all doorphones.
4
After entering all data, pressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-7-00 Doorphone Assignment
1-7-01 Doorphone Display Time Selection
1-7-04 Doorphone Ringing Pattern Selection
1-7-05 Doorphone Ringing Frequency Selection
N
Telephone ports A0~C0 are ports 100~120.
0 1 / 0 3 : D P H D A Y
T I M E D I S P L A Y
Data
No.
Title
Tel Port
No.
(01~99)
A0~C0
To Next Page
Loading...
