NEC Xen IPK - IP Station Number Assignment

472 – Chapter 1 DRAFT 3 IP Station Number Assignment, 4-67
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
4-67
System Mode
4
Submode
—
Data No.
67
PC Programming
+ BTT
IP Station Number
Assignment
General Description
Use this Memory Block to assign a station number for each IP telephone supported by the
IPCA( )-U( ) ETU
.
Display
Programming Procedures
1
Go off-line.
2
Press LK4 +FF to access the Memory Block.
3Note:Use dial pad to assign a 2- (00~99), 3- (000~999) or 4-digit (0000~9999) station
number for each Tel Port No.:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data or Tel Port No.
– OR –
R to go to next assigned Tel Port No.
Q + Ato enter A for Port Numbers 100~109.
Q + Bto enter B for Port Numbers 110~119.
Q + Cto enter C for Port Number 120.
4
PressNto write the data and display the next Memory Block.
5
Program the next Memory Block or pressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46 Access Code (1-Digit) Assignment
1-1-47 Access Code (2-Digit) Assignment
1-2-03 2-, 3-, or 4-Digit Station Number Selection
4-10 Station Number Assignment
N
Telephone Ports A0~C0 are ports 100~120.
0 1 / 6 7 : I P I C M
T I M E D I S P L A Y
Tel Port
No.
(01~CO)
Data
No.
Title
Setting
Data