NEC Xen IPK - Tone Assignment

234 – Chapter 1 DRAFT 3 Tone Assignment, 1-8-15
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-8-15
System Mode
1
Submode
8
Data No.
15
PC Programming
+ BI
Tone Assignment
General Description
Use this Memory Block to assign each system tone to the flexible tables.
Display
Settings
(Page 1)
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Tone A Tone B Tone C Tone D
LK 5 LK 6 LK 7 LK 8
Tone E Tone F Tone G Tone H
(Page 2)
LK 1 LK 2 LK 3 LK 4
Tone I Tone J Tone K Tone L
LK 5 LK 6 LK 7 LK 8
Tone M
Programming Procedures
1
Go off-line.
2
Press LK1 + LK8 + AEto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the Setting Data option.
Use
K~I to enter Table No.
4
PressNto write the data and advance to the next table.
5
After entering last data, pressNto write the data.
6
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
1 5 : ( 0 0 ) D T = A | 1
T I M E D I S P L A Y
Data
No.
Tone
Page
No.
Item
No.
(00~12)
Setting
Data