NEC Xen IPK - PBX Line Ringing Pattern Selection

1-1-52, PBX Line Ringing Pattern Selection DRAFT 3 Chapter 1 – 89
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-52
System Mode
1
Submode
1
Data No.
52
PC Programming
+ BCS
PBX Line Ringing Pattern
Selection
General Description
Use this Memory Block to assign the initial ringing pattern for incoming calls on a PBX line.
Display
Settings
(Page 1)
LK 1 LK 2 LK 3 LK 4
Ring Pattern A
Ring Pattern B Ring Pattern C Ring Pattern D
LK 5 LK 6 LK 7 LK 8
Ring Pattern E Ring Pattern F Ring Pattern G Ring Pattern H
(Page 2)
The shaded area indicates the
default setting.
LK 9 LK 10 LK 11 LK 12
No Ring
LK 13 LK 14 LK 15 LK 16
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + EBto access the Memory Block.
3
Press corresponding CO/PBX line key to change data.
Note: Use the following to enter data:
Sto access the next page
Tto access the previous page
4
Press Nto write data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
Do not program this Memory Block if Memory Block 1-1-59 Synchronous Ringing Selection is assigned Yes.
5 2 : P B X P T N B | 1
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Page
No.