NEC Xen IPK - PRT B Channel Outgoing Priority Selection

1-13-04, PRT B Channel Outgoing Priority Selection DRAFT 3 Chapter 1 – 277
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-13-04
System Mode
1
Submode
13
Data No.
04
PC Programming
+ AN
PRT B Channel Outgoing
Priority Selection
General Description
Use this Memory Block to assign the Outgoing Priority for the B-channels when calls are
originated on a PRT(1)-U( ) ETU.
This assignment is allowed by handset programming and SAT.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded area
indicates the
default setting.
H J L
High to Low
L J H
Low to High
Programming Procedures
1
Go off-line.
2
Press LK1+ LK13 +KDto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data. The next Memory Block is displayed.
5
Program the next Memory Block or pressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
1-13-00 PRI Channel Assignment
N
This Memory Block applies to all firmware versions of the PRT(1)-U( ) ETU.
0 1 / 0 4 : C H S L C = H J L
T I M E D I S P L A Y
PRT
(1-2)
Title
Setting
Data
Data
No.