NEC Xen IPK - DISA;ID Password Effect;Invalid Selection

256 – Chapter 1 DRAFT 3 DISA/ID Password Effect/Invalid Selection, 1-9-02
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-9-02
System Mode
1
Submode
9
Data No.
02
PC Programming
+ BD
DISA/ID Password Effect/
Invalid Selection
General Description
Use this Memory Block to assign a Direct Inward System Access (DISA) Password as Invalid
(LK1) or Effective (LD2). If invalid is assigned, the calling party can use the DISA feature without
a DISA Password.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
No
Yes
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK9 + KB to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Setting Data:
NO (LK1) = DISA Password Invalid (Password is not required).
YES (LK2) = DISA Password in Effect (Password is required. Assign with MB , 1-1-46~, 1-1-48).
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
R to access the next ID buffer number
Q+1, 2, 3 = A, B, or C for Port Number
ID Buffer Number: 01~99 = 01~99
A0~A9 = 100~109
B0~B9 = 110~119
C0 = 120
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2, Guide to Feature Programming.
0 1 / 0 2 : P A S W O R D = Y S
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
ID Buffer No.
(01~C0)