NEC Xen IPK - PBR Interdigit Release Timer Selection

1-8-10, PBR Interdigit Release Timer Selection DRAFT 3 Chapter 1 – 229
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-8-10
System Mode
1
Submode
8
Data No.
10
PC Programming
+ BM
PBR Interdigit Release Timer
Selection
General Description
Use this Memory Block to specify the interdigit release time for the Push Button Receiver (PBR).
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
3 sec. 4 sec. 5 sec. 6 sec.
LK 5 LK 6 LK 7 LK 8
7 sec. 8 sec. 9 sec. 10 sec.
Programming Procedures
1
Go off-line.
2
Press LK1 + LK8 + AKto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-3-03 First Digit PBR Release Timer Selection
1-8-01 SLT or Automated Attendant/DISA to PBR Selection
N
A DTMF Single Line Telephone connected to the Xen system must be supported by a PBR that receives DTMF signals.
1 0 : P B R R E L E A S 7 s
T I M E D I S P L A Y
Data
No.
Title
Setting
Data