NEC Xen IPK - Printer Line Feed Control Selection

1-5-14, Printer Line Feed Control Selection DRAFT 3 Chapter 1 – 193
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-5-14
System Mode
1
Submode
5
Data No.
14
PC Programming
+ AS
Printer Line Feed Control
Selection
General Description
This Memory Block specifies the format of the data sent to the Station Message Detail Recording
(SMDR) printer. If YES is set, a carriage return is provided with the call record.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
Yes No
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK5 +ADto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-5-02 SMDR Print Format
1-5-13 Printer Connected Selection
1-5-25 SMDR Valid Call Timer Assignment
N
Example: Settings to specify the format of communication data output to the printer.
 Line Feed control in effect.
07/03/92 09:00 08-05-12 OG 123
00:15:32 102885167537000 LCR FWD234
12345678
 No Line Feed control.
07/03/92 09:00 08-05-12 OG 123 00:15:32 10288516753700 LCR IWD234
12345678
(No Limit)
1 4 : L I N E F E E D N O
T I M E D I S P L A Y
Data
No. Title
Setting
Data