NEC Xen IPK - Second Delay Announcement Repeat Interval Time Selection

116 – Chapter 1 DRAFT 3 Second Delay Announcement Repeat Interval Time Selection, 1-1-75
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-1-75
System Mode
1
Submode
1
Data No.
75
PC Programming
+ AR
Second Delay Announcement
Repeat Interval Time Selection
General Description
Use this Memory Block to specify the interval time to repeat Second Delay Announcement to the
calling party.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
0 sec. 10 sec.
20 sec. 30 sec.
LK 5 LK 6 LK 7 LK 8
40 sec. 50 sec. 60 sec. No Limit
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + GE to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-73 First to Second Delay Announcement Interval Time Selection
1-1-74 Second Delay Announcement Repeat Selection
3-43 ACD/UCD Delay Announcement Assignment
N
This Memory Block does not display unless the MIFA-U( ) ETU is installed.
7 5 : M S G 2 R P E T = 2 0 s
T I M E D I S P L A Y
Data
No.
Setting
Data
Title