3-59, Automated Attendant Function Selection DRAFT 3 Chapter 1 – 389
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
3-59
System Mode
3
Submode
—
Data No.
59
PC Programming
+ AI
Automated Attendant
Function Selection
General Description
Use this Memory Block to specify if the Automated Attendant is to operate in the Normal Mode,
or the Automated Attendant Delay Announcement mode.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
A.A. Normal
(A.A./DISA)
A.A. Delay
Announcement
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK3 + N + EI to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Example: To change A.A. Normal (A.A./DISA) to A.A. Delay Announcement, press CO/PBX line key 2.
R to go to the next CO/PBX Line No.
4
PressNto write the selected data and advance to Next CO Number’s Memory Block , 3-00 , Trunk Name/Number
Assignment.
5
PressPto go back on-line.
Related Programming
General
Information
ISDN Caller Name Indication Selection
1-4-18 Automated Attendant Delay Announcement Assignment
1-4-19 Automated Attendant 1
st
to 2
nd
Delay Announcement Interval Time Selection
1-4-20 Automated Attendant Delay Announcement Disconnect Time Selection
0 1 / 5 9 : A . A . N O R M A L
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting Data
To Next Page
Loading...
