NEC Xen IPK - Telephone to Tenant Assignment

416 – Chapter 1 DRAFT 3 Telephone to Tenant Assignment, 4-09
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
4-09
System Mode
4
Submode
—
Data No.
09
PC Programming
+ BTT
Telephone to Tenant
Assignment
General Description
Use this memory block to specify, per station, Tenant Assignment.
Display
Programming Procedures
1
Go off-line.
2
Press LK4 + KI to access the Memory Block.
3
Use dial pad to enter data for Tenant Numbers 00 ~47.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
R to move to the next Tel No.
Default Values
All Telephones Tenant 00
4
After entering all data, PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
2-01 Trunk to Tenant Assignment
2-05 Line Key Selection
2-06 Line Key Selection for Tenant Mode
2-07 System Speed Dial Display Assignment
2-08 ECR Relay to Tenant Assignment
N
1. Stations can be assigned to one of 48 Tenant Number (00 ~ 47).
2. The Call Pickup Group is determined by Tenant assignment.
3. Telephone ports A0~C0 are ports 100~120.
0 1 / 0 9 : T E N A N T = 0 0
T I M E D I S P L A Y
Data
No.
Title
Tel Port
No.
(01~99)
A0~C0
Setting
Data
(00~47)