NEC Xen IPK - System Speed Dial Memory Clear

8-2, System Speed Dial Memory Clear DRAFT 3 Chapter 1 – 515
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
8-2
System Mode
8
Spd-Clr-Sys
2
Data No.
—
PC Programming
+ BE
System Speed Dial Memory
Clear
General Description
Use this Memory Block to clear all System Speed Dial programming.
N
Before programming this procedure, please ensure you understand completely the
affect of erasing all System Speed Dial buffers in the system.
Display
Programming Procedures
1
Go off-line.
2
Press LK8 + LK2 to access the Memory Block.
3
When the system display prompt indicates CLR TEL SPD?, the first four CO/PBX lines light red.
4
Press HAHIto enter the fixed password.
Note: When entering the password the top line of CO/PBX LEDs change from red to green each time a number of the password
is pressed.
5
PressNto write the data.
6
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
C L R S Y S S P D ?
T I M E D I S P L A Y
WWWW
Red Red Red Red
H =
WWWW
Green Red Red Red
WWWW
A =
Green Green Red Red
WWWW
H =
Green Green Green Red
WWWW
I =
Green Green Green Green