NEC Xen IPK - Modem Port for Remote Programming Assignment

1-8-38, Modem Port for Remote Programming Assignment DRAFT 3 Chapter 1 – 251
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-8-38
System Mode
1
Submode
8
Data No.
38
PC Programming
+ CSS
Modem Port for Remote
Programming Assignment
General Description
A socket modem can be installed on the MIFM-U( ) ETU when it is installed in S1 or S2 of the
B64-U23 KSU. Use this Memory Block to assign the extension number for the socket modem.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK8 + CH to access the Memory Block.
3
Use dial pad to enter number of digits.
Note: Use the following to enter data:
K~I to enter digits
J to move cursor left
L to move cursor right
Default Values
Not assigned
Setting Data Extension No.
00 ~ 99
000 ~ 999
0000 ~ 9999
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
N
Modem Extension number is a phantom number. It does not have to be assigned in MB 4-10.
3 8 : M O D E M =
T I M E D I S P L A Y
Data
No.
Title
Setting
Data