1-11-02, Line Length Selection DRAFT 3 Chapter 1 – 263
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
1-11-02
System Mode
1
Submode
11
Data No.
02
PC Programming
+ AD
Line Length Selection
General Description
Use this Memory Block to specify the distance, in feet, between the channel service unit/
demarcation (CSU/D mark) and the DTI-U( ) ETU. This specifies the equalization values of
the detect signal in the DTI-U( ) ETU
.
Applicable for R2000 and above.
Display
Settings
LK1 LK2 LK3 LK4 LK5 LK6 LK7 LK8
The shaded area indicates
the default setting.
1
(0–131)
2
(132–262)
3
(263–393
4
(394–524)
5
(525–655)
Programming Procedures
1
Go off-line.
2
Press LK1 + LK11 + KB to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data. The next Memory Block is displayed.
5
Program the next Memory Block or pressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
N
The DTI-U( ) ETU must be assigned in the system to set this Memory Block.
0 1 / 0 2 : L I N E = 1
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
DTI No.
(01~08)
Line Key LCD Indication Description
LK1 1 0~131 Feet
LK 2 2 132~262 feet
LK 3 3 263~393 feet
LK 4 4 394~524 feet
LK 5 5 525~655 feet
To Next Page
Loading...
