NEC Xen IPK - Programming Modes

Xen IPK Programming Manual
Programming Manual DRAFT 3 Chapter 1 – 3
Doc. No.: 8194 - Release 2.0 December 2004
2.2 System Programming Modes
System programming has eight modes and some modes have
submodes. The modes and submodes are listed in Table 1-1:
Programming Modes.
Table 1-1: Programming Modes
Line
Key
Mode Name
Line
Key
Submode Name
LK 1 System Mode LK 1 CO LIne
LK 2 ICM
LK 3 SLT
LK 4 Transfer/Automated Attendant
LK 5 SMDR/LCR
LK 6 DSS
LK 7 ESP
LK 8 PBR/Miscellaneous
LK 9 DISA
LK 10 CAR
LK 11 DTI
LK 12 ACD/UCD
LK 13 PRI ISDN
LK 14 ACR
LK 15 K-CCIS
LK 2 Tenant Mode N/A N/A
LK 3 CO/PBX Line Mode N/A N/A
LK 4 Telephone Mode N/A N/A
LK 5 Trunk Group Mode N/A N/A
LK 6 Copy Mode LK 2 Tenant Mode Copy Assignment
LK 3 CO Line Mode Copy Assignment
LK 4 Telephone Mode Copy Assignment
LK 5 Trunk Group Mode Copy Assignment
LK 7 ETU Mode LK 1 Card Interface Slot Assignment
LK 2 Telephone Type Assignment
LK 3 MIF Assignment
LK 8 Special Mode LK 1 ROM Version Confirmation
LK 2 System Speed Dial Memory Clear
LK 3 Station Speed Dial Memory Clear
LK 8 Second Initialisation