1-1-76, Barge-In Alert Tone Assignment DRAFT 3 Chapter 1 – 117
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
1-1-76
System Mode
1
Submode
1
Data No.
76
PC Programming
+ BTS
Barge-In Alert Tone
Assignment
General Description
Use this Memory Block to assign the delayed ringing timer for incoming outside line calls.
Applicable to IPK R2000 and above.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK5 LK6 LK7 LK8
The shaded area indicates
the default setting.
YS NO
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + GF to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option. Default Values
15 Seconds
4
PressNto write the data and display the next Memory Block.
5
Program the next Memory Block or pressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-8-08 Class of Service (Station) Feature Selection 2
4-17 Station to Class of Service Feature Assignment
4-90 SLT Data Line Security Assignment
N
1. Monitoring telephone conversations may be illegal under certain circumstances and laws. Consult a legal advisor
before implementing the monitor of conversations. Some federal and state laws require a monitoring party to use an
alert tone to indicate monitoring and/or obtain consent from all parties to the conversation. Some laws provide strict
penalties for illegal monitoring of telephone conversations.
2. When YS is assigned, both internal and external parties receive the alert tone.
7 6 : A L E R T T O N E = Y S
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
To Next Page
Loading...
