NEC Xen IPK - CO Line Ringing Pattern by Telephone or CO Selection

4-57, CO Line Ringing Pattern by Telephone or CO Selection DRAFT 3 Chapter 1 – 463
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
4-57
System Mode
4
Submode
—
Data No.
57
PC Programming
+ BTT
CO Line Ringing Pattern by
Telephone or CO Selection
General Description
Use this memory block to select if CO or Telephone is to have ring pattern.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
CO Telephone
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK4 +EG to access the Memory Block.
3
Press the corresponding CO/PBX line key to change data option
Note: Use the following to change option:
R to move to the next Tel Port No.
Default Values
:
CO
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-70 CO Line Ringing Pattern Selection for CO/PBX Line Mode
4-55 CO Ringing Pattern Selection for Telephone Mode
0 1 / 5 7 : R N G P R I C O
T I M E D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Setting
Data
Title