NEC Xen IPK - Intercom Master Hunt Number Forward Assignment

4-15, Intercom Master Hunt Number Forward Assignment DRAFT 3 Chapter 1 – 423
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
4-15
System Mode
4
Submode
—
Data No.
15
PC Programming
+ BTT
Intercom Master Hunt
Number Forward Assignment
General Description
Use this Memory Block to specify a telephone to ring when a Master Hunt Number specified in
Memory Block , 4-14 , Intercom Master Hunt Number Selection is busy.
Display
Programming Procedures
1
Go off-line.
2
Press LK4 + AEto access the Memory Block.
3
Use dial pad to enter data. To set Tel. Port No. 01 to forward station number 300,
enter 300.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
U clear data when cursor is at setting data
R to move to the next Tel Port No.
Setting Data: Forward Station Number is one of the following:
• 2 digit (00 ~ 99)
• 3 digit (000 ~ 999)
• 4 digit (0000 ~ 9999)
Default Values
All Telephones Not Specified
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
4-14 Intercom Master Hunt Number Selection
N
Telephone ports A0~C0 are ports 100~120.
0 1 / 1 5 : I C M F W D
T I M E D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Setting
Data
Title