1-15-02, Common Signal Channel Assignment DRAFT 3 Chapter 1 – 293
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
1-15-02
System Mode
1
Submode
15
Data No.
02
PC Programming
+ AW
Common Signal Channel
Assignment
General Description
Use this Memory Block to assign a T1 Trunk to be a Common Signalling Channel.
Applicable for IPK R2000 and above.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK15 + KB to access the Memory Block.
3
Use dial pad keys to select Table number
Note: Use the following pad keys to enter Setting Data:
Jto move cursor left.
Lto move cursor right.
K~Ito enter numeric data.
Default Values
:
00
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-10 Calling Name Display Allow/Deny Selection
1-15-11 Centralised Billing Allow/Deny Selection
0 2 : C S C 1 = C O 0 0
T I M E D I S P L A Y
Data
No.
Setting
Data
C-Channel
1~4
Title
To Next Page
Loading...
