NEC Xen IPK - System Refresh Timer Assignment

1-8-11, System Refresh Timer Assignment DRAFT 3 Chapter 1 – 231
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-8-11
System Mode
1
Submode
8
Data No.
11
PC Programming
+ BM
System Refresh Timer
Assignment
General Description
Use this Memory Block to assign the System Refresh Time during idle periods/no change
in state.
Display
Settings
LK 1 LK 2LK 3LK 4
The shaded area indicates
the default setting.
No Refresh
4 hr. 8 hr. 12 hr.
LK 5 LK 6 LK 7 LK 8
24 hr.
Programming Procedures
1
Go off-line.
2
Press LK1 + LK8 + AAto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. The system automatically refreshes itself during idle periods based on the time specified in this Memory Block.
2. If there is a call in progress during Refresh Time activity and no other actions occurring in the system at that time, the
system will refresh.
1 1 : R E F R E S H 4 H
T I M E D I S P L A Y
Data
No.
Title
Setting
Data