NEC Xen IPK - Trunk Group Mode Copy Assignment

6-5, Trunk Group Mode Copy Assignment DRAFT 3 Chapter 1 – 499
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
6-5
System Mode
6
Trunk Group
5
Data No.
—
Trunk Group Mode Copy
Assignment
General Description
Use this Memory Block to enable copying data from one Trunk Group to another Trunk Group or
multiple consecutive Trunk Groups.
Example: To copy data of Trunk Group 01 to Trunk Groups 10~14:
1. Enter the original Trunk Group using the dial pad; press 01~32.
2. Press
N.
Display
Programming Procedures
1
Go off-line.
2
Press LK6 + LK5 to access the Memory Block.
3
Enter the Trunk Group to be copied.
Note: Use the following to enter data:
K~I to enter numeric data
U to clear all data when placed at cursor position
Related Programming
No related programming is necessary for this Memory Block.
T R K G P — —
Æ
T I M E D I S P L A Y
Title
Setting
Data
T R K G P 0 1 — —
Æ
T I M E D I S P L A Y
Title
Setting
Data
— —
Æ
T R K G P —
T I M E D I S P L A Y
Title
Setting
Data