NEC Xen IPK - Polarity Reverse Selection

402 – Chapter 1 DRAFT 3 Polarity Reverse Selection, 3-90
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
3-90
System Mode
3
Submode
—
Data No.
90
PC Programming
+ AN
Polarity Reverse Selection
General Description
In some cases a Central Office may provide a line reversed to provide a disconnect signal.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
No
Yes
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK3 + N + IK to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
R to go to the next CO/PBX Line No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
BRI and PRI lines are to be set to YES at all times.
1 1 / 9 0 : R V R S ( Y S )
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Setting Data
(20 digits maximum)