NEC Xen IPK - Link Reconnect Allow;Deny Selection

306 – Chapter 1 DRAFT 3 Link Reconnect Allow/Deny Selection, 1-15-08
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-15-08
System Mode
1
Submode
15
Data No.
08
PC Programming
+ AW
Link Reconnect Allow/Deny
Selection
General Description
Use this Memory Block to specify the number of digits to be collected by the system before
the message is sent to the network
.
Applicable for IPK R2000 and above.
Display
Settings
LK1 LK2 LK3 LK4 LK5 LK6 LK7 LK8
The shaded area indicates
the default setting.
NO
(Deny)
YS
(Allow)
Programming Procedures
1
Go off-line.
2
Press LK1 + LK15 + KH to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-10 Calling Name Display Allow/Deny Selection
0 8 : M A X D G T 0 1 = 2 4
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Route
01~32