NEC Xen IPK - Station Transfer;Camp-On Recall Timer Selection

1-1-12, Station Transfer/Camp-On Recall Timer Selection DRAFT 3 Chapter 1 – 45
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-12
System Mode
1
Submode
1
Data No.
12
PC Programming
+ BM
Station Transfer/Camp-On
Recall Timer Selection
General Description
Use this Memory Block to specify the time interval before a Ring Transfer or Station Camp-On
from a station (without an Attendant Add-On Console) recalls back to the originating station when
the call is not answered.
For R2000 only.
For R2000 and above.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
25 sec.
45 sec. 60 sec. 90 sec.
LK 5LK 6LK 7LK 8
120 sec. 180 sec. 240 sec. No Limit
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + AB to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + AB to access the Memory Block.
1 2 : T R F R E C L 6 0 s
T I M E D I S P L A Y
Data
No. Title
Setting
Data
1 2 : T R F C L X = 0 6 0 s
T I M E D I S P L A Y
Data
No. Title
Setting
Data
Class