1-8-01, SLT or Automated Attendant/DISA to PBR Selection DRAFT 3 Chapter 1 – 217
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
1-8-01
System Mode
1
Submode
8
Data No.
01
PC Programming
+ BTI
SLT or Automated Attendant/
DISA to PBR Selection
General Description
Use this Memory Block to specify whether the four Push Button Receiver (PBR) circuits in the
CPUI( )-U( ) ETU Unit are used for Single Line Telephones or the Automated Attendant/Direct
Inward System Access (DISA).
Display
Settings
LK 1LK 2LK 3LK 4
There is no
default setting.
PBR 1
and 2
PBR 3
and 4
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK8 + KAto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
The LED indication changes to indicate the data each time the CO/PBX line key is pressed.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. If LK1 and LK2 are assigned to Automated Attendant/DISA, the PBR( )--13 ETU must be installed in the system if
Single Line Telephones are used.
2. For Automated Attendant to function at least one PBR must be set.
0 1 : P B R ( S L T / A A )
T I M E D I S P L A Y
Data
No.
Title
CO/PBX
Line LED
Off On
Data
Single Line
Telephone
A.A./DISA
The shaded area indicates
the default setting.
To Next Page
Loading...
