NEC Xen IPK - Common Signalling Channel Route Assignment

5-05, Common Signalling Channel Route Assignment DRAFT 3 Chapter 1 – 489
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
5-05
System Mode
5
Submode
—
Data No.
05
PC Programming
+ AW
Common Signalling Channel
Route Assignment
General Description
Use this Memory Block to specify the Common Signalling Channel for each voice trunk
group used for K-CCIS
.
Applicable for IPK R2000 and above.
Display
Settings
LK1 LK2 LK3 LK4 LK5 LK6 LK7 LK8
The shaded area indicates
the default setting.
01234
Programming Procedures
1
Go off-line.
2
Press LK5+ N + KE to access the Memory Block.
Note: Use the following to enter data:
Jto move cursor left
Lto move cursor right
K~ Ito enter numeric data
Default Values
:
0 (Not Assigned)
CCH: 1~4
3
PressNto write the data.
4
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-70
CIC Number Assignment
1-1-05
Start Time Selection
1-1-46~48
Access Code (1-, 2- or 3-Digit) Assignment
1-15-00
K-CCIS Main/Remote Office Selection
1-15-02
Common Signal Channel Assignment
1-15-03
Originating Point Code Assignment
1-15-04
Destination Point Code Assignment
1-15-05
Destination Point Code Transfer Assignment
1-15-06
Originating Office Code Number Assignment
1-15-07
K-CCIS Message Response Time Assignment
1-15-08
Link Reconnect Allow/Deny Selection
0 1 / 0 5 : C C H C H 0
T I M E D I S P L A Y
Trunk Group No.
(01~32)
Data
No.
Title
Setting
Data