2-08, ECR Relay to Tenant Assignment DRAFT 3 Chapter 1 – 337
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
2-08
System Mode
2
Submode
—
Data No.
08
PC Programming
+ BN
ECR Relay to Tenant
Assignment
General Description
Use this Memory Block to specify Tenant Assignment for External Tone Ring/Night
Chime function.
Display
Settings
LK 1LK 2LK 3LK 4
There is no
default value.
External
Tone Relay
1
External
Tone
Relay 2
External
Tone
Relay3
External
Tone
Relay 4
LK 5 LK 6 LK 7 LK 8
Night Chime
Programming Procedures
1
Go off-line.
2
Press LK2 + KHto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J to moves the cursor left
L to moves the cursor right
R to go to the next Tenant No.
Default Values
All Tenants No Assignment
4
Press the Nto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-7-07 External Ring Relay Cycle Selection
N
1. By assigning Night Chime to a Tenant, incoming calls to the Tenant Group in Night Mode can be answered using the
Night Call Pickup Access Code.
2. The relays are fixed (non programmable).
3. Night Chime must be assigned for Night Call Pickup to work. A relay may be assigned even if no ECR-U( ) ETU is
installed in the system.
0 0 / 0 8 : R L Y T E N A N T
T I M E D I S P L A Y
Data
No.
Tenant No.
(00~47)
Title
To Next Page
Loading...
