NEC Xen IPK - Automatic Day;Night Mode Switching Time Assignment

62 – Chapter 1 DRAFT 3 Automatic Day/Night Mode Switching Time Assignment, 1-1-27
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-1-27
System Mode
1
Submode
1
Data No.
27
PC Programming
+ BM
Automatic Day/Night Mode
Switching Time Assignment
General Description
Use this Memory Block to assign Pattern 1 and Pattern 2 start times for automatically switching
between Day Mode and Night Mode.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + BG to access the Memory Block.
3
Enter the data using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
U to clear all data when the cursor is in the Data No. position
Default Values
Not Specified
4
PressNto write the data. The switching time for pattern 2 is displayed.
5
Use the dial pad to change the time.
6
PressNto write the data.
7
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-32 Automatic Day/Night Mode by Day of Week Selection
1-4-05 Automatic Tandem Trunk by Night Mode Selection
1-8-07 Class of Service (Attendant) Feature Selection 1
4-07 Code Restriction Class Assignment (Day Mode)
4-08 Code Restriction Class Assignment (Night Mode)
4-09 Telephone to Tenant Assignment
4-17 Station to Class of Service Feature Assignment
4-37 Extension Line Key Ring Assignment (Day Mode)
4-38 Extension Line Key Ring Assignment (Night Mode)
2 7 : 1 : , :
T I M E D I S P L A Y
Data
No.
Day Mode
Start Time
Setting Data
Pattern
(1/2)
Night Mode
Start Time
Setting Data