NEC Xen IPK - Tie Line First Ring Pattern Selection

1-1-34, Tie Line First Ring Pattern Selection DRAFT 3 Chapter 1 – 71
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-34
System Mode
1
Submode
1
Data No.
34
PC Programming
+ ALN
Tie Line First Ring Pattern
Selection
General Description
Use this Memory Block to set specific ringing tones for incoming calls on Tie lines. After a delay
interval specified in Memory Block 1-1-07
Tie Line Delay Ringing Timer Selection, a Tie call can
ring at all Day/Night ring-assigned telephones using a different cadence.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Pattern 1 Pattern 2
Pattern 3 Pattern 4
LK 5LK 6LK 7LK 8
ICM Voice
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + CDto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-07 Tie Line Delay Ringing Timer Selection
1-1-53 Tie Line Delay Ring Pattern Selection
4-01 CO/PBX Ring Assignment (Day Mode)
4-02 CO/PBX Ring Assignment (Night Mode)
N
1. Specify one pattern in the Ringing Pattern Selection Table.
2. If Voice is selected, switching from voice to tone is not allowed, Memory Block 1-1-07 is not used, and Handsfree
Answerback is not allowed at the receiving station.
3 4 : T L I R N G P A T 3
T I M E D I S P L A Y
Data
No. Title
Setting
Data