NEC Xen IPK - Trunk Group Outgoing Priority Selection

5-06, Trunk Group Outgoing Priority Selection DRAFT 3 Chapter 1 – 491
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
5-06
System Mode
5
Submode
—
Data No.
06
PC Programming
+ ALN
Trunk Group Outgoing
Priority Selection
General Description
Use this Memory Block to assign the Outgoing Priority for trunk access to each Trunk
Group. This is normally used with a Tie Line or K-CCIS network to reverse the search order
and reduce call collisions during trunk seizure
.
Applicable for IPK R2000 and above.
Display
Settings
LK1 LK2 LK3 LK4 LK5 LK6 LK7 LK8
The shaded area indicates
the default setting.
H → L
High to Low
L → H
Low to High
234
Programming Procedures
1
Go off-line.
2 Press LK5 +N+KFto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
Nto write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46~48 Access Code (1-, 2- or 3-Digit) Assignment
Function 201~232 – Route Advance Block 01~32
Function 401~416 – Closed Number Block 01~32
Function 601~604 – ACR Table 1~4
1-1-30 Route Advance Block Assignment
1-1-49 Networking Trunk Group/Route Advance Assignment
1-14-04 ACR Trunk Group to Route Number Assignment
N
This Memory Block should not be assigned (use default) for trunk groups with trunks belonging to an IAD(8)-
U( ) ETU used with IP (K-CCIS) or IP (K-CCIS) to NEAX (Point-to-Multipoint).
0 1 / 0 6 : P R I O R . H > L
T I M E D I S P L A Y
Trunk Group No.
(01~32)
Data
No.
Title
Setting
Data