NEC Xen IPK - Centralised Billing - Point Code of Centre Office Assignment

314 – Chapter 1 DRAFT 3 Centralised Billing – Point Code of Centre Office Assignment, 1-15-12
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-15-12
System Mode
1
Submode
15
Data No.
12
PC Programming
+ AW
Centralised Billing – Point
Code of Centre Office
Assignment
General Description
Use this Memory Block to assign the Common Signalling Channel number and point code
of the Billing Center Office (NEAX2000/2400)
.
Applicable for IPK R2000 and above.
Display
Settings
LK1 LK2 LK3 LK4 LK5 LK6 LK7 LK8
The shaded area indicates
the default setting.
NO
(Deny)
YS
(Allow)
Programming Procedures
1
Go off-line.
2
Press LK1 + LK15 + AB to access the Memory Block.
3 Use dial pad keys to enter C-Channel and Point Code.
Note: Use the following to enter data:
Jto move cursor left.
Lto move cursor right.
K~Ito enter numeric data.
Point Code range is 0001~16367.
Default Values
:
Blank
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1 2 : B I L C C H 0
T I M E D I S P L A Y
Data
No.
Title
Point
Code
C-Channel
1~4