136 – Chapter 1 DRAFT 3 Customised Message 1~10 Assignment, 1-2-09~18
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0
December 2004
1-2-09~18
System Mode
1
Submode
2
Data No.
09~18
PC Programming
+BI
Customised Message 1~10
Assignment
General Description
Use this Memory Block to program various messages for display at a station LCD. When a user
places an intercom (ICM) call from a station equipped with an LCD display to a station in DND
mode, the appropriate programmed message displays at the calling station.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK2 + KI~AH to access the Memory Block.
3
Enter the options using the dial pad.
Note: Use the following enter data:
J to move the cursor left
L to move the cursor right
K~Ito enter numeric data
U to clear data
Default Values
4
Enter the characters to be displayed. Refer to Section 7, Character Code Tables.
5
After entering all data for Memory Block , 1-2-09~18 , Customised Message 1~10 Assignment, pressNto write the
data.
6
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. Ten messages are available, the first six are assigned at default.
2. Ten messages are available, the first six are assigned at default.
3. System Software allows a message to be entered using the dial pad instead of the ASCII Character Code Tables.
Follow the procedure in Appendix B Character Codes, Section 1 Character Assignment on page B-1.
0 9 : D O N ‘ T D I S T U R B
T I M E D I S P L A Y
Data
No.
Setting Data
(13 Digits max.)
Data No. Message
09 DON’T DISTURB
10 MEETING
11 BUSINESS TRIP
12 NOT IN
13 WITH GUEST
14 OUT OF OFFICE
15
~18
Not Specified
To Next Page
Loading...
