NEC Xen IPK - DIT Delay Answer Timer Selection

390 – Chapter 1 DRAFT 3 DIT Delay Answer Timer Selection, 3-61
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
3-61
System Mode
3
Submode
—
Data No.
61
PC Programming
+ AU
DIT Delay Answer Timer
Selection
General Description
This Memory Block is used to specify the time an incoming CO/PBX Call will ring before
changing to DIT.
With IPK R2000 and above, this memory block allows flexible entry.
For R2000 only.
For R2000 and above.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
0s
5s 10s 20s
LK 5 LK 6 LK 7 LK 8
30s 40s 50s 60s
Programming Procedures
1
Go off-line.
2
Press LK3 + N + AEto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
R= Next CO/PBX Line No.
4
PressNto write the data.
5
PressPto go back on-line.
Display
1 1 / 6 1 : D Y L A N S O S
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
CO/PBX
No.
(01~64)
1 1 / 6 1 : D L Y A N S 0 0 s
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
CO/PBX
No.
(01~64)