NEC Xen IPK - MIF (UCD) Assignment

7-3-03, MIF (UCD) Assignment DRAFT 3 Chapter 1 – 511
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
7-3-03
System Mode
7
MIF
3
Data No.
03
PC Programming
+ BS
MIF (UCD) Assignment
General Description
Use this Memory Block to enable the Uniform Call Distribution (UCD) function on the MIFA-
U( ) ETU.
Display
Programming Procedures
1
Go off-line.
2
Press LK7 + LK3 + J + J + KC to access the Memory Block.
3
Use the dial pad to enter data.
Note: Use the following are used when entering data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
Setting Data 00, 01, 02
Default Values
No Assignment (00)
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
0 3 : U C D M I F = 0 0
T I M E D I S P L A Y
Data
No.
Title
Setting Data