NEC Xen IPK - Automated Attendant Message to Tenant Assignment

1-4-12, Automated Attendant Message to Tenant Assignment DRAFT 3 Chapter 1 – 177
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-4-12
System Mode
1
Submode
4
Data No.
12
PC Programming
+ AU
Automated Attendant Message
to Tenant
Assignment
General Description
Use this Memory Block to assign Automated Attendant Messages to Tenant.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK4 + ABto access the Memory Block.
3
Use the dial pad to enter data.
Note: Use the following to enter data:
A~H to enter Automated Attendant message number.
K~I to enter Tenant Number.
Default Values
All Automated Attendant Messages:
Tenant No. 00
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2, Guide to Feature Programming.
N
If a tenant is not assigned to a specific automated message, the Automated Attendant sends the message assigned in
Memory Block , 1-4-11 , Automated Attendant Message Day Night Mode Selection.
1 2 : A A 1 T N A T = 0 0
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
A.A.
No.
1~8