NEC Xen IPK - Receiving Volume Selection

4-92, Receiving Volume Selection DRAFT 3 Chapter 1 – 477
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
4-92
System Mode
4
Submode
—
Data No.
92
PC Programming
+ BTM
Receiving Volume Selection
General Description
Use this Memory Block to specify whether receiving volume is returned to normal (DOWN) or
kept as is (UP) on a call after hanging up.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
Down Up
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK4 +IB to access the Memory Block.
3
Press the corresponding CO/PBX line key to change data option.
Use the following to change option:
R select next Tel Port No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-28 Distinctive Ringing by Telephone or CO Selection
N
1. Receiving Volume Down:
Multiline Terminal: The volume (increased by
T+ 2) is reset when you hang up.
Single Line Telephone: Normal.
2. Receiving Volume Up:
Multiline Terminal: The volume (increased by
T+ 2) is not reset when you hang up.
Single Line Telephone: The volume is increased 6 dB.
3. This feature applies to internal and external calls.
4. Telephone ports A0~C0 are ports 100~120.
0 1 / 9 2 : R C V D O W N
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Title
Setting
Data