NEC Xen IPK - K-CCIS Message Response Timeout Assignment

304 – Chapter 1 DRAFT 3 K-CCIS Message Response Timeout Assignment, 1-15-07
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-15-07
System Mode
1
Submode
15
Data No.
07
PC Programming
+ AW
K-CCIS Message Response
Timeout Assignment
General Description
Use this Memory Block to assign the time before a call or message request is cancelled
when no response is received from the destination office
.
Applicable for IPK R2000 and above.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK15 + KG to access the Memory Block.
3 Use dial pad keys to enter Setting Data.
Note: Use the following to enter data:
Jto move cursor left.
Lto move cursor right.
K~Ito enter numeric data.
Note: Setting Data:
00 =
∞ (infinity)
01~99 Seconds are valid times.
Default Values
:
30 Seconds
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
0 7 : R E S T I M E 3 0 s
T I M E D I S P L A Y
Data
No.
Setting
Data
Title