NEC Xen IPK - Hookflash Start Time Selection

158 – Chapter 1 DRAFT 3 Hookflash Start Time Selection, 1-3-05
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-3-05
System Mode
1
Submode
3
Data No.
05
PC Programming
+ BTI
Hookflash Start Time
Selection
General Description
Use this Memory Block to specify the minimum hookflash duration from Single Line Telephone.
Display
Settings
(Page 1)
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
40 ms. 90 ms. 140 ms. 190 ms.
LK 5 LK 6 LK 7 LK 8
240 ms. 290 ms. 340 ms. 390 ms.
(Page 2)
LK 1 LK 2 LK 3 LK 4
440 ms. 490 ms. 540 ms. 590 ms.
LK 5 LK 6 LK 7 LK 8
640 ms. 690 ms. 740 ms. 790 ms.
Programming Procedures
1
Go off-line.
2
Press LK1 + LK3 + KE to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data
option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-3-01 Bounce Protect Time Selection
1-3-06 Hookflash End Time Selection
N
1. Press hookswitch during CO/PBX call to place the line on hold or send hookflash to CO/PBX.
2. Bounce Protect Time [Memory Block 1-3-01 Bounce Protect Time Selection] and Hookflash Start Time must be
equal.
0 5 : F L S H S T 4 0 | 1
T I M E D I S P L A Y
Setting
Data
Title
Data
No.
Page
No.