NEC Xen IPK - Networking Trunk Group;Route Advance Assignment

84 – Chapter 1 DRAFT 3 Networking Trunk Group/Route Advance Assignment, 1-1-49
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-1-49
System Mode
1
Submode
1
Data No.
49
PC Programming
+ BCS
Networking Trunk Group/
Route Advance Assignment
General Description
Use this Memory Block to assign the function number of the Trunk Group to be used to network
an Xen system to another system by Tie lines or CO/PBX/CTX lines.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + DI to access the Memory Block.
3
Use dial pad to enter the Function Number of the Trunk Group or the Route Advance
Block.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~Ito enter numeric data
U to clear all data
Default Values
Not Specified
4
PressNto write selected data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-30 Route Advance Block Assignment
3-03 Trunk-to-Trunk Group Assignment
1-1-50 CO/PBX Outgoing Digit Add Assignment
N
Function Number 101~132 (Trunk Group 1~32, respectively) or 201~216 (Route Advance Block 1~16,
respectively) is assigned to Closed Number blocks.
4 9 : 0 1 = R T
T I M E D I S P L A Y
Data
No.
Closed
Number Block
01~16
Enter
Function
No.