NEC Xen IPK - Automatic Tandem Trunk by Night Mode Selection

1-4-05, Automatic Tandem Trunk by Night Mode Selection DRAFT 3 Chapter 1 – 173
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-4-05
System Mode
1
Submode
4
Data No.
05
PC Programming
+ AT
Automatic Tandem Trunk by
Night Mode Selection
General Description
This Memory Block is used to establish whether or not the Automatic Trunk-to-Trunk Transfer
feature follows the Night Mode assignment.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
No Yes
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK4 + KE to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-27 Automatic Day/Night Mode Switching Time Assignment
1-1-33 Speed Dial Number/Name Display Selection
3-05 Trunk Incoming Answer Mode Selection
3-06 Automatic Tandem Trunk Assignment
0 5 : T A N D B Y N T N O
T I M E D I S P L A Y
Data
No. Title
Setting
Data