NEC Xen IPK - Hold Recall Time Selection (Exclusive)

1-1-63, Hold Recall Time Selection (Exclusive) DRAFT 3 Chapter 1 – 103
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-63
System Mode
1
Submode
1
Data No.
63
PC Programming
+ BM
Hold Recall Time Selection
(Exclusive)
General Description
Use this Memory Block to specify the time for Exclusive Hold Recall. If No Limit is selected,
Exclusive Hold Recall is not provided.
With IPK R2000 and above, this memory block allows flexible entries and has four classes.
For R2000 only.
For R2000 and above.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
0.5 min.
1 min. 1.5 min. 2 min.
LK 5LK 6LK 7LK 8
3 min. 5 min. 8 min. No Limit
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + FC to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + FC to access the Memory Block.
6 3 : H O L D R E C L 1 . 0
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
6 3 : H O L D R C L X = 0 6 0 s
T I M E D I S P L A Y
Data
No.
Setting
Data
Title Class