NEC Xen IPK - LCD Line Key - Name Assignment

4-68, LCD Line Key – Name Assignment DRAFT 3 Chapter 1 – 473
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
4-68
System Mode
4
Submode
—
Data No.
68
PC Programming
+ BTT
LCD Line Key – Name
Assignment
General Description
Use this Memory Block to assign a name to each LCD Line Key of the DTR-16LD-1
Telephone. Up to eight characters can be assigned
.
Display
Programming Procedures
1
Go off-line.
2
Press LK4 +FH to access the Memory Block.
3Note:Use dial pad to change Line Key number or name.
J to move the cursor left
L to move the cursor right
K~I to enter numeric data or Tel Port No.
– OR –
R to go to next assigned Tel Port No.
Q + Ato enter A for Port Numbers 100~109.
Q + Bto enter B for Port Numbers 110~119.
Q + Cto enter C for Port Number 120.
Default Value:
LK01~08: CO 01~08
4
PressNto write the data and display the next Line Key and Name.
5
Repeat Steps 3 and 4 for each Line Key assignment. After Line key 16 is programmed, the next Tel Port No. is displayed.
When you want to program less than 16 keys, after the last Line key to program, press
Rto go to next assigned Tel
Port No. After all Tel Ports are assigned, the next Memory Block is displayed.
6
Program the next Memory Block or pressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-2 Telephone Type Assignment
4-12 Line Key Selection for Telephone Mode
N
1. Telephone Ports A0~C0 are ports 100~120.
2. The name can be entered using the dial pad. Follow the procedures in Appendix B Character Codes.
3. The default names listed in the table below are assigned based on the line key type from Memory Block 4-12 (Line
Key Selection for Telephone Mode)
0 1 / 6 7 : L K O 1 N A M E
< C O 0 1 >
Title
Line Key
01~16
Data
No.
No.
(01~CO)
Setting Data