446 – Chapter 1 DRAFT 3 LCR Class Selection, 4-40
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0
December 2004
4-40
System Mode
4
Submode
—
Data No.
40
PC Programming
+ BTT
LCR Class Selection
General Description
Use this Memory Block to specify, per station, the Least Cost Routing (LCR) Class. The Xen IPK
has four Area Code Tables. Each LCR Class can have different Trunk Group access to allow
priority levels for the station user.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Class 0Class 1Class 2Class 3
LK 5 LK 6 LK 7 LK 8
Class 4
Programming Procedures
1
Go off-line.
2
Press LK4 +DK to access the Memory Block.
3
Press the corresponding CO/PBX line key to change data option.
Note: Use the following to change option:
Rto select next Tel Port No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. LCR Class Selection corresponds to Area Code Tables as follows:
Class 0 No LCR
Class 1 Use Area Code Table 1
Class 2 Use Area Code Table 2
Class 3 Use Area Code Table 3
Class 3 Use Area Code Table 3
2. Stations cannot be assigned to multiple LCR Classes.
3. An MIFM PAL must be installed in the system to support this feature.
4. Telephone ports A0~C0 are ports 100~120.
5. Access Code must always be used in order to access LCR Trunk Group 1.
0 1 / 4 0 : L C R C L S = 0
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Title
Setting
Data
To Next Page
Loading...
